VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Repairing Kustom Amps » Kustom 100 issues
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Kustom 100 issues [message #27140] Thu, 20 December 2018 12:52 Go to next message
jaybee is currently offline  jaybee
Messages: 3
Registered: December 2018
Junior Member
Amp lost power. How do I remove the chassis from the cabinet? Can someone link me to this and/or troubleshooting tips? Thanks.

Report message to a moderator

Re: Kustom 100 issues [message #27141 is a reply to message #27140] Fri, 21 December 2018 06:20 Go to previous messageGo to next message
stevem is currently offline  stevem
Messages: 4775
Registered: June 2004
Location: NY
Senior Member
there are 4 screws on the bottom of the cabinet ( not the ones that hold the metal feet on) remove them and the chassis will slide out from the rear.

There is a glass fuse inside mounted near the on/ off switch and if it's blown / open then it's time to take the amp to a repair tech.
If the fuse is good then the wall plug end of the power cord may have gone bad.

Report message to a moderator

Re: Kustom 100 issues [message #27142 is a reply to message #27140] Fri, 21 December 2018 09:11 Go to previous messageGo to next message
jaybee is currently offline  jaybee
Messages: 3
Registered: December 2018
Junior Member
It never occurred to me to look at the bottom. (slaps head)

thanks a bunch!

Report message to a moderator

Re: Kustom 100 issues [message #27143 is a reply to message #27140] Sat, 22 December 2018 06:08 Go to previous message
stevem is currently offline  stevem
Messages: 4775
Registered: June 2004
Location: NY
Senior Member
If you find that your fuse is good and your power cord is bringing wall voltage into the amp then the next thing to look at is the thermal circuit breaker in the amp as they do go bad at times.
You can just ohm check it to see if it's open ,or jump it out with Clip lead.

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: K150-8
Next Topic: Kustom Organ Effects Loop
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat Nov 09 05:51:47 EST 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software