| Re: KUSTOM - Hustler and Commander [message #25234 is a reply to message #25232] |
Sun, 17 July 2016 06:50   |
stevem
Messages: 4749
Registered: June 2004
Location: NY
|
Senior Member |
|
|
The first thing to do with either amp is to unplug and plug back in a few times all of the white Molex connectors that these amps have from board to board.
On the Female pins in these connector you can tighten them up with a needle nose .
On the reverb issue do the same thing to its RCA cable at each end, but also spin them as you take them on and off as the Female's ends on both the pan side and board tarnish up really bad at times.
Be very carefull when plugging the Molex connectors back into place as you should try to support the under side of the board where the connectors are solder into.
See if these 10 minute worth of things helps out!
[Updated on: Sun, 17 July 2016 06:53] Report message to a moderator |
|
|
|
VintageKustom.com
Search
Help
Members
Register
Login
Home
