VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Repairing Kustom Amps » K200B6
Show: Today's Messages :: Polls :: Message Navigator
Return to the default flat view Create a new topic Submit Reply
K200B6 [message #28291] Tue, 10 August 2021 17:08 Go to previous message
aeroboy47 is currently offline  aeroboy47
Messages: 15
Registered: September 2019
Junior Member
I posted last year about this amp. It's the one that had a #12 wire soldered across the fuse and had several bad transistors and the shorted bias diodes. After I got the parts replaced and the amp working again, I was concerned about the 120mv DC voltage at the output. I'm back working on it now and I have replaced other parts and the DC voltage at the output is now 48mv DC. I'm guesssing that 0vdc would be ideal but dont see that happening unless someone has ideas about what to do nest. I have replaced Q1-Q4, Q701-Q709 and CR701-CR703. All the voltage readings I have been able to take are very close to the schematic values except Q707 collector is at -2.4 vdc and Q703 collector is at +4.6vdc. Any technical expertise would be appreciated.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Schematic for Kustom Studio Series
Next Topic: L 995 RV Amp Repair
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sun Nov 17 10:19:22 EST 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software