VintageKustom.com: Repairing Kustom Amps » Bright channel doesn't work on 200B-1

Home » VintageKustom.com » Repairing Kustom Amps » Bright channel doesn't work on 200B-1 (Looking for suggestions on fixing 200B-1 bright channel )

Show: Today's Messages :: Polls :: Message Navigator

Bright channel doesn't work on 200B-1 [message #29191]

Thu, 30 November 2023 19:17

KactiKarrot
Messages: 1
Registered: November 2023

Junior Member

I've recently acquired a 200B-1 head and cab, and on the normal channel, everything works great. The bright channel, however, doesn't work at all. The only way to get any noise is by turning the volume to max, which results in a barely audible distorted sound coming through. The bright switch on the bright channel also pops quite loudly when turned. I've opened up the head and can't see anything jarringly wrong such as bulging capacitors or anything like that. Any help on fixing this would be appreciated!

Report message to a moderator

Re: Bright channel doesn't work on 200B-1 [message #29192 is a reply to message #29191]

Fri, 01 December 2023 06:28

stevem
Messages: 4775
Registered: June 2004
Location: NY

Senior Member

The problem is that the first and maybe second gain stage transistor has gone bad when this problem is seen..

If you go to this sites technical page and open up the schematic for a PC105 board you will see the input jack feeding transistor Q100 and then that transistor feeding Q101.

I would replace both of these since they are less a dallor each these days.

You can order them from NTE parts direct.

Q100 crosses to a NTE123AP

Q101 crosses to a NTE129

I would get a few of each just in case you might need then down the road.

Report message to a moderator

Previous Topic:	Kustom K100-5B
Next Topic:	Repairing a Kustom TBR400

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Wed Nov 13 22:03:03 EST 2024