VintageKustom.com: Repairing Kustom Amps

Home » VintageKustom.com » Repairing Kustom Amps » Need schematic (Kustom J695)

Show: Today's Messages :: Polls :: Message Navigator

Need schematic [message #29287]

Thu, 11 July 2024 09:10

HutchAmpMan
Messages: 4
Registered: June 2022

Junior Member

I need a schematic for a Kustom J695 two channel amp head. S/N is 10762

The amp had one bad power transistor (replaced with a NOS unit) but has low volume and distortion when volume is set high. Without a schematic, I'm just reduced to guessing.

There are no markings on the PC boards as to what number they are. The amp uses three power transistors, the first of which is connected to the preamp board with the other two paralleled from that. The audio board is mounted on three points to the chassis bottom via 90 degree tabs.

Any help would be appreciated.

Thanks!
Tom

Report message to a moderator

[Message index]

		Need schematic By: HutchAmpMan on Thu, 11 July 2024 09:10
		Re: Need schematic By: stevem on Thu, 11 July 2024 15:22
		Re: Need schematic By: stevem on Thu, 11 July 2024 15:33
		Re: Need schematic By: HutchAmpMan on Fri, 12 July 2024 09:31
		Re: Need schematic By: stevem on Fri, 12 July 2024 10:15
		Re: Need schematic By: HutchAmpMan on Fri, 12 July 2024 12:17
		Re: Need schematic By: HutchAmpMan on Fri, 12 July 2024 12:15

Previous Topic:

pot meters

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Jul 13 18:05:13 EDT 2024