VintageKustom.com: Replacement Part Suggestions

Home » VintageKustom.com » Replacement Part Suggestions » Info About FLH-15 and M15

Show: Today's Messages :: Polls :: Message Navigator

Info About FLH-15 and M15 [message #17240]

Wed, 27 June 2012 04:16

cato
Messages: 1
Registered: June 2012
Location: Denmark

Junior Member

HEY

I have purchased a Kustom FLH-15 front loading horn with a Rola driver and a M-15 top with Altec Horn and a driver where there is written:
Kustom 832. what EV driver is that?

What Bass driver can I replace the Tola driver with? JBL K130? JBL 2226H?
Is the ROla driver 8 Ohm?

Do anaybody have the original Dividing network plans? Cause my network is kind of homemade. Or anybody have som suggestions to a good network?

How low does the FLH-15 go?

Thanks...

Report message to a moderator

Re: Info About FLH-15 and M15 [message #17241 is a reply to message #17240]

Wed, 27 June 2012 08:08

pleat
Messages: 1454
Registered: June 2004
Location: Belding, Mi

Senior Member

It's hard to tell after almost 40 years what might be in any of the cabinets. The FLH15 low cutoff is 40Hz with the original standard speaker and 35Hz with the EV (SRO version) speaker.
The M-15 horn came with an Electro Voice 1823 driver. The crossover (?) a photo would help to determine if it is something that someone has added. Most Kustom horns use a simple capacitor 10Md as the crossover.
As far as replacement speakers for the FLH cabs, you need to determine the amps impedance for a total load. If the amp runs max output at 4 ohm and the FLH are the only cabs, then you will want 8 ohm speakers for a 4 ohm total load, and the brand is really up to you.
pleat

Report message to a moderator

Previous Topic:	K200A footswitch?
Next Topic:	boost/wah pedal

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat Nov 02 03:02:25 EDT 2024