VintageKustom.com
VintageKustom.com is your source for literature and information on the tuck-and-roll vintage Kustom amps from the 60's and 70's, as well as their related products such as guitars and organs . We provide a webboard for help with kustom gear history, technical information and repairs as well as discussions with other collectors.
Home » VintageKustom.com » Comment Board » Newbie with very basic questions about a 200 PA
Show: Today's Messages :: Polls :: Message Navigator
Switch to threaded view of this topic Create a new topic Submit Reply
Newbie with very basic questions about a 200 PA [message #17538] Fri, 12 October 2012 20:01 Go to next message
Burt_Macklin is currently offline  Burt_Macklin
Messages: 2
Registered: October 2012
Location: Madison, WI
Junior Member
Hey, guys. I recently acquired a 200 series pa. I don't know much about musical equipment at all so I am hoping you can help me out a little bit.
model: K 200B 5
serial: 40840

I have basically only four questions.

1- Why are there two 'on' positions?

2- how old is this?

3- There is an extra input/output jack on the backside. (bottom right if you are looking at the back) What is it for?

4- Is there anyway I can make it sound more clear? Right now it sounds kind of.. cloudy. And there is always white/static noise coming from them (although you can only hear it when there is no music on). Don't get me wrong, they sound great, but just not as clear and crisp as other systems I have heard. Right now I attribute that to the fact that they are probably very old.

Thank you so much for you help!!

http://i1169.photobucket.com/albums/r511/Mitch_Kramer/0707121202.jpg

http://i1169.photobucket.com/albums/r511/Mitch_Kramer/1012121849.jpg

[Updated on: Fri, 12 October 2012 20:18]

Report message to a moderator

Re: Newbie with very basic questions about a 200 PA [message #17539 is a reply to message #17538] Fri, 12 October 2012 20:34 Go to previous messageGo to next message
pleat is currently offline  pleat
Messages: 1454
Registered: June 2004
Location: Belding, Mi
Senior Member
Welcome, the power switch has two on positions which is a polarity switch. If you get a lot of buzz or shocks when touching other equipment, switching to the opposite on position should eleminate the shock hazard. Most of us replace the two prong power cable with a grounded three pin power cable.
The 1/4" jack on the lower right back panel is the for the footswitch cutoff for the reverb, the RCA jack is for driving another slave amp or tape deck.
As far as the tone, the system is designed for vocal, not as much for guitar. The system should date to around late 68 to mid 71 so depending on what might have been done to the amp over the years is something to consider when judging the amps tone.
I know I've owned several K200B-5 heads and they sound great with a guitar cab.
pleat

Report message to a moderator

Re: Newbie with very basic questions about a 200 PA [message #17541 is a reply to message #17538] Fri, 12 October 2012 20:47 Go to previous messageGo to next message
rodak
Messages: 516
Registered: October 2001
Location: Georgia
Senior Member
Nice looking PA!
Pleat, just to confirm, when you say it was designed for vocals, you mean just the speaker columns, right? All K200s have he same preamp and power amp circuits (except, of course, for the effects), whether bass, guitar or PA, right?

In fact, there weren't any specialized circuits for guitar/bass/vocals in any of the Frank/plexi series, were there? Were the slant-front amps the same way (i.e., same circuits, differing only in effects, # of channels, etc)?

www.combo-organ.com

Report message to a moderator

Re: Newbie with very basic questions about a 200 PA [message #17542 is a reply to message #17541] Fri, 12 October 2012 21:16 Go to previous messageGo to next message
pleat is currently offline  pleat
Messages: 1454
Registered: June 2004
Location: Belding, Mi
Senior Member
Yes, all amps in each series used the same power amp, there were differences in the pre amps. Bright channels vs. normal channels, main differences were what kind of effects or lack of effects the amp has.
pleat

Report message to a moderator

Re: Newbie with very basic questions about a 200 PA [message #17543 is a reply to message #17541] Fri, 12 October 2012 22:44 Go to previous messageGo to next message
chicagobill
Messages: 2006
Registered: April 2003
Senior Member
rodak wrote on Fri, 12 October 2012 19:47
All K200s have he same preamp and power amp circuits (except, of course, for the effects), whether bass, guitar or PA, right?

Yes that's basically true, but like Pleat said, there were a few differences in the preamps.

The K200B-5 that we have here uses 4 basic preamps that are the same as the ones used on the K200B-1 guitar amps, but the bright switch has been replaced with the reverb control.

Report message to a moderator

Re: Newbie with very basic questions about a 200 PA [message #17545 is a reply to message #17543] Sat, 13 October 2012 22:17 Go to previous message
BC
Messages: 583
Registered: March 2000
Location: Kentucky
Senior Member
I have played bass with Kustom PA heads and they work quite well. Also the extra channels are good for a keyboard player to use. The secret with 200 Series amps is match a cabinet appropriate for the application. 4 ohm Load is what they like. BC Cool

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Kustom 150 Price and Pedal Question
Next Topic: Reverb on vintage Kustoms
Goto Forum:
  

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ]

Current Time: Sat Nov 09 10:44:01 EST 2024
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software