VintageKustom.com: Replacement Part Suggestions » where can i find a whatchamahoozit for a k150-2?

Home » VintageKustom.com » Replacement Part Suggestions » where can i find a whatchamahoozit for a k150-2? (broken diody thing blues)

Show: Today's Messages :: Polls :: Message Navigator

where can i find a whatchamahoozit for a k150-2? [message #28959]

Tue, 28 February 2023 21:02

pinkjimiphoton
Messages: 45
Registered: May 2015
Location: the dark side of the moon

Member

hi fam
working on a kustom k150-2, had a super weak output.... someone had replaced the heat sinked germanium driver transistors with a mismatched set of si npn/pnp and one of the power transistors had base disconnected.
i found the "nte equivalents" and got the proper heat sinks off a donor carcass i have. of course replacing these resulted in the fuse instantly blowing quite spectacularly. Wink

when i had it apart, i disconnected that diode looking thing that sits between the power transistor from its clip/heat sink and one of the dang legs broke off right at the case.
i'm a fair solderhand, but no way to tag this puppy.

does anyone have a spare they wanna part with, or a substitute part? i believe this is being used as a thermostat?

any advice gratefully accepted with thanks
peace
PjP

Report message to a moderator

Re: where can i find a whatchamahoozit for a k150-2? [message #28960 is a reply to message #28959]

Wed, 01 March 2023 12:20

stevem
Messages: 4775
Registered: June 2004
Location: NY

Senior Member

That's a 1n3654 diode mounted in the clip between the two output Transistors.

There a NOS one for sale right now on eBay.

There are no Germainium Transistors in these model Kustoms so that was non original and would not work right in the circuit since they need a different value components around them to bias them since they are not silicon based.

Until you confirm that everything is right I would only use a 1.5 amp fuse so you stand less of a chance of blowing a bunch of stuff up.

Report message to a moderator

Re: where can i find a whatchamahoozit for a k150-2? [message #28982 is a reply to message #28960]

Wed, 15 March 2023 12:15

chicagobill
Messages: 2006
Registered: April 2003

Senior Member

There is a typo in your post, the correct number is 1N3754.

Report message to a moderator

Previous Topic:	.5 watt or 1watt resistors
Next Topic:	K100-1 power indicator light bulb and assembly

Goto Forum:

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

]

Current Time: Sat Nov 16 12:29:19 EST 2024